Brick Panel Installation; Intake/Exhaust Manifold Removal & Vent Install - Majestic 40ICFDVLNTSC Installation And Operating Instructions Manual

INSTALLATION
IMPORTANT: The fireplace must have an approved brick
kit or porcelain panel kit installed before operation.

BRICK PANeL INSTALLATION

Figure 13
Kit contents:
1, Rear Panel 2, Upper Brick Retainer Brackets
1, Left Panel 2, Lower Brick Retainer Brackets
1, Right Panel 2, Front Brick Retainer Brackets
4, Self-tapping Screws
1. Remove brick panels and retainers from packaging.
2. Remove two (2) screws on each side of front edge of
chamber.
3. Install one (1) front brick retainer bracket on each side
with the screws removed in Step 2.
4. Carefully set rear brick panel with notch up on log sup-
port.
5. Carefully place right or left side brick panel in place
making sure front edge of brick is behind the front brick
retainer bracket.
6. Using self-tapping screw, install upper brick retainer
bracket (with two (2) holes and slot with the long side
down into the top of the inner chamber.
7. Using self-tapping screw, install lower brick retainer
bracket (smaller bracket) into the log support bracket
centered on brick panel.
8. Repeat Steps 6 & 7 for remaining side.
Remove Screws
Left Brick
Rear Brick Panel
Panel
with Notch Up
Upper Brick
Retainer
Bracket
Lower Brick
Retainer
Bracket
Front Brick
Retainer
Figure 13 -
Install Brick Panels
20304734
Log
Support
Right Brick
Panel
FP2984
install brick panels
INTAKe/exhAuST MANIFOLD ReMOVAL
AND VeNT INSTALLATION
The intake/exhaust manifold is shipped attached to insert.
It may be removed to allow tight installation.
1. Unfasten the two (2) machine screws on the face of the
unit and release the plate assembly by sliding the plate
back.
2. Attach the exhaust and the intake flex pipes to the collar
on the plates with a hose clamp (not provided) or other
approved methods (check local codes).
Exhaust Collar
Machine
Screws
Figure 14
3. Slide plate assembly back in place under locating
FP2979
tabs.
intake exhaust
4. While sliding unit in place, if necessary the glass latch/
shutoff tool can be used to help place the plate assem-
bly. Using the small end of the tool, insert it in the square
notch in top front of firebox. Hook the plate assembly
with tool and pull forward into place while sliding firebox
to the rear. Figure 15
5. Reinstall and tighten machine screws.
Plate
Assembly
FP2985
Latch Tool
40ICFDV Gas Fireplace Insert
Intake Collar
Exhaust/Intake
Slide Plate
Assembly
FP2979
FP2977
Figure 15
15