Majestic 40ICFDVLNTSC Installation And Operating Instructions Manual page 37

TOuCh SCReeN ReMOTe CONTROL OPeRATION
n using the Mounting Base
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
1. Secure the mounting base
on the wall with supplied
screws. For best viewing
angle, make it the same
height as your eyes.
2. Hang the transmitter on the
hook of the mounting base,
then push down so the
transmitter is flush to the
mounting base.
Symptom
1. Battery icon on LCD on transmitter
2. LCD display is blank
3. LCD display shows "funny" display
4. Appliance does not come on
5. Blower is not on after the fireplace is
turned on
20304734
Figure 51
FP2674
TROuBLeShOOTING
mounting base
Causes
1. Low Battery
2. The transmitter did not match
with the receiver
3. Transmitter measures temp-
erature exceeding 99 degrees
Fahrenheit and shows "HI" on
LCD
4. Distance between the transmitter
and receiver is more than 30 feet
5. Blower setting is off
6. Blower delay setting is set too
high
40ICFDV Gas Fireplace Insert
Action
1. Replace batteries. Change batteries
every 6 months.
2. Check battery installation or replace
batteries.
3. Reset the transmitter (see "Resetting
the Transmitter" section).
1. Make sure the transmitter has
learned to the receiver.
1. Move transmitter to a cooler place
and wait until temperature drops
below 99 degrees.
1. Make sure the opening distance is
less than 30 feet.
1. Press FAN key to select Fan speed
you desire.
1. Press and hold FAN key to set
desired ON/OFF delays. This is done
in minutes.
37