Table of Contents
Advertisement
This gas fireplace should be installed by a qualified installer
accordance with local building codes and with current CAN
;GA-B149 (. l or .2) Installation codes for Gas Burning
ireplaces and Equipment. If the unit is being installed in a
mobile home the installation should comply with the current
CAN/CSA Z 240 .4 code.
FOR U.S.A Installations follow local codes and/or the current
National Fuel Gas Code. ANSI 2223.
I.
FOR SAFE INSTALLATION AND OPERATION
PLEASE NOTE THE FOLLOWING:
I
This fireplace gives off high temperatures and should be
located out of high traffic areas and away from furniture
and draperies.
2
Children and adults should be alerted to the hazards of the
high surface temperatures of this fireplace and should stay
away to avoid burns
w
ignition of clothing.
3
Children should be carefully supervised when they are in
the same room as your fireplace.
4
Under no circumstances should this fireplace be modified.
Parts removed for servicing should be replaced prior to
operating the fireplace again.
5
Installation and any repairs to this fireplace should be
carried out by a qualified service person. A professional
service person should be contacted to inspect this fireplace
annually. Make it a practice to have all of your gas fire-
places checked annually. More frequent cleaning may
be required due to excess lint and dust from carpeting,
bedding material, etc.
6
Control compartments, burners and air passages in this
fireplace should be kept clean and free of dust and lint.
Make sure that the gas valve and pilot light are turned off
before you attempt to clean this fireplace.
7
The venting system (chimney) of this fireplace should be
checked at least once a year and if needed your venting
system should be cleaned.
8
Keep the area around your fireplace clear of combustible
materials, gasoline and other flammable vapour and liq-
uids. This fireplace should not be used as a drying rack for
clothing, nor should Christmas stockings or decorations
be hung on or around the fireplace.
9
Under no circumstances should any solid fuels (wood,
coal, paper or cardboard etc.) be used in this fireplace.
• 10 The flow of combustion and ventilation air must not be
obstructed in any way.
11 When the fireplace is installed directly on carpeting, vinyl
tile or any combustible material other than wood, the
fireplace must be installed on a metal or wood panel
extending the full width and depth of the fireplace.
12 This fireplace requires adequate ventilation and
combustion air to operate properly.
3 This fireplaces must not be connected to a chimney flue
serving a separate solid fuel burning fireplace.
14 When the fireplace is not in use it is recommended that the
gas control valve be left in the "OFF" position.
IMPORTANT:
PLEASE REVIEW THE FOLLOWING
CAREFULLY
Remove any plastic from trim parts before turning the
fireplace ON.
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the start
up or cool down cycle. Similar noises are found with your
furnace heat exchanger or car engine.
It is not unusual for your Majestic gas fireplace to give
off some odour the first time it is burned. This is due to
the curing of the paint and any undetected oil from the
manufacturing process.
Please ensure that your room is well
ventilated - open all windows.
It is recommended that you bum your Majestic fireplace
for a least six (6) hours the first time you use it. If optional
fan kit has been installed, place fan in the "OFF" position
during this time.
.
LOCATING YOUR
FIREPLACE . • ...
'"
;- Fig.
I.
A) *Flat on wall comer
C) Island
B) *Room divider
_ , D) Cross comer
E) Flat on wall
*
A
& B must maintain a 12" (305 mm) clearance between the
wall and side glass of fireplace.
A
There is a minim11m vertical rise required for
the venting which varies depending on the
application. The maximum horizontal run also
has restrictions. Become familiar with the venting
instructions starting on page 9, before starting the
installation.
Adequate clearances as listed below must be maintained
for servicing and proper operation:
BACK ....................................................
O"
SIDE .................................................. 12"
FLOOR······················"····""''''''"''''''""'
O"
ToP ....................................................
36"
CORNER .......................
O"
ro BAcK EoGES
VENT PIPE ............................................ l"
10001948/1 -Page 3 -
Advertisement
Table of Contents
Troubleshooting
