Check Gas Pressure; Gas Shutoff Tool - Majestic 40ICFDVLNTSC Installation And Operating Instructions Manual

Clean face direct vent fireplace insert

Hide thumbs

Table Of Contents

Table of Contents

40ICFDV Gas Fireplace Insert

1. Check gas type. The gas supply must be the same as

stated on the appliance's rating decal. If the gas supply

is different from the fireplace, STOP! Do not install the

appliance. Contact your dealer immediately.

2. To ease installation, a 24" (610 mm) flex line with manual

shut-off valve has been provided with on this appliance.

Install and attach 1/2" gas line onto shut-off valve.

3. After completing gas line connection, purge air from

gas line and test all gas joints from the gas meter to

the fireplace for leaks. Use a solution of 50/50 water

and soap solution or a gas sniffer.

4. To check gas pressures at valve, turn captured screw

counter clockwise 2 or 3 turns and then place tubing

to pressure gauge over test point. Turn unit to high.

Figure 19. After taking pressure reading, be sure and

turn captured screw clockwise firmly to reseal. Do not

over torque. Check test points for gas leaks.

Do not use open flame to

check for gas leaks.

GAS ShuTOFF TOOL

The glass frame removal tool shown on Page 14, Figure

12 can also be used to turn off the gas supply to the unit's

gas valve. Figure 20

1. Insert the narrow end of the tool with the rectangular

cutout, onto the protrusion on the gas shutoff located at

the front end of the valve.

2. Turn to the right until the protrusion on the shutoff is

horizontal.

3. The gas is now off to the appliance.

NOTe: In some installations, the optional doors may need

to be opened to provide access to the the gas shutoff.

Pressure Outlet

Figure 19 -

Signature Command Valve

FP1909a

Glass Frame

signature command valve

Removal Tool

alternate view

8/08

Figure 20 -

Use the Glass Frame Removal Tool

to Turn Off Gas Supply