Setting The Error Retry Mode - Monarch 9906 Operator's Handbook Manual

S e t t i n g t h e E r r o r R e t r y M o d e
You can set how the printer operates after a supply error has been cleared. The printer
can either reprint the job or discard/cancel the job. If you enable error retry, the printer
reprints the job that was in process when the error occurred. If you disable error retry, the
printer discards the job that was in process.
To change the setting, from the Main Menu, select Setup, then Defaults. Then, follow
these steps.
1. Press  or  until you see Error Retry.
DEFAULTS
 Error Retry
Enable
CHANGE
2. Press CHANGE to highlight the error retry options. The current setting is shown.
3. Press  or  to scroll through the error retry options.
DEFAULTS
Error Retry

Enable
SET
4. When you see the error retry mode you need, press SET to save the change. Press
CANCEL to leave the error retry mode unchanged.
DEFAULTS
 Error Retry
Enable
CHANGE
Press BACK until you return to the Home/Online screen.
5.

BACK

CANCEL

BACK
Setting Defaults 6-15