Monarch 9906 Operator's Handbook Manual page 26

L o a d i n g R i b b o n
Make sure the printer is configured to use a ribbon.
To load ribbon:
1. Open the cover.
2. Unlock the printhead by turning the retaining latch.
3. Lift the printhead assembly using the printhead tab until the assembly locks into place.
4. Push the deflector tab down.
5. Slide an empty ribbon core on the take-up reel as far as it will go.
6. Remove the new ribbon from the package. Do not wrinkle or crush the ribbon.
3-2 Operator's Handbook
Take-u p
Reel
Printhead
As sembl y
Deflector
Tab
Retaining Latch