Solaris Issues Fixed In Solaris 10 10/08 - Fujitsu SPARC Enterprise M3000 Product Notes

Solaris OS Issues Fixed in Solaris 10 5/09 (Continued)
TABLE 9
CR ID Description
6689757 Sun Dual 10 GigE Fiber XFP Low Profile
Adapter (XGF) with a single or improperly
installed XFP optical transceivers might cause
the following error to show on the console:
The XFP optical transceiver is
broken or missing.
6725885 cfgadm will display non-existent SPARC
Enterprise M3000 system boards (SB1 to SB15).

Solaris Issues Fixed in Solaris 10 10/08

TABLE 10
encounter them in supported releases earlier than Solaris 10 10/08.
Solaris OS Issues Fixed in Solaris 10 10/08
TABLE 10
CR ID Description
6608404 Hot-plug of the X4447A-Z, PCI-e Quad-port
Gigabit Ethernet Adapter UTP card might
cause other network devices to fail.
6679370 The following message may be output on the
console during the system booting.
SUNW-MSG-ID: SUN4-8000-75, TYPE:
Fault, VER: 1, SEVERITY: Critical
...
DESC:
A problem was detected in the PCI-
Express subsystem.
Refer to http://sun.com/msg/SUN4-
8000-75 for more information.
...
lists issues that have been fixed in Solaris 10 10/08 OS. You might
Workaround
This has been fixed in patch 139570-01.
[Workaround]
Check and make sure that both XFP optical
transceivers are firmly seated in the housing.
Do not mix INTEL and Sun XFP optical
transceivers in the same Adapter.
Do NOT plumb a port with the ifconfig
command if the port does not contain an XFP
optical transceiver or it contains one but the
transceiver is not in use.
This has been fixed in patch 140401-01.
The cfgadm output for SB1-SB15 can be
ignored.
Workaround
To avoid the defect, do not install this card.
This has been fixed in patch 137137-09.
Note -
Before adapting the patch, delete the
following setting from /etc/system:
set pcie_expected_ce_mask = 0x2001
[Workaround]
Add the following to /etc/system and then
reboot the domain.
set pcie_expected_ce_mask = 0x2001
Information About Software 25