Fujitsu SPARC Enterprise M3000 Product Notes page 28

XCP Issues Fixed in Releases Earlier Than XCP
TABLE 6
ID Description
RTIF1- In a system connecting multiple hosts and one
090220-001 or more I/O units with RCI, the power-on
operation to one of those RCI hosts may not
power on any of the RCI I/O units.
RTIF1- After replaced the motherboard unit, the RCI
090220-002 power interlocking setting restores to its
default value.
RTIF1- Despite the normal status of ppp network
090427-001 interface for the XSCF-to-Solaris OS
communication, SNMP MIB notifies abnormal
(down) status.
RTIF1- After you set https (using the self certificate
090430-001 authority) by XSCF and created a web server
certificate, https is not enabled.
RTIF1- In a domain mounted with the 10 Gigabit
090508-001 Ethernet card (SE0X7HE1F), when you set the
OpenBoot PROM environmental variable
diag-switch? to true, the following
warning message appears on the console; and
at the same time, "Msg: Device error
(FCode informed error)" is recorded in
the error log.
WARNING: /pci@7,700000: FCODE map-
in doesn't match decoded register
type;
And when you execute the showstatus(8)
command, "Degraded" might be indicated to
the FRU which has installed the relevant card.
20 SPARC Enterprise M3000 Server Product Notes for XCP Version 1091 • April 2010
1091
(Continued)
Workaround
All the RCI hosts shall be powered on.
If you have set the power interlocking to a
value other than the default, replace the
motherboard unit and then use the
setpwrmode(1M) command to set the power
interlocking setting again.
No workaround is available.
To set the self certificate authority, do not
specify a blank character.
The entire output can be safely ignored.
To avoid these outputs, execute the following
command at the ok prompt and set the
OpenBoot PROM environmental variable
diag-switch? to false.
setenv diag-switch? false