Charging The Battery - Invacare Electric Portable Patient Lift RPA600-1E Operating & Maintenance Manual

SECTION 3—OPERATION

Charging the Battery

NOTE: For this procedure, refer to FIGURE 3.5.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound when battery is low.
1. Lift up on the handle on the back of the battery.
2. Lift the battery up and away from the control box.
Make sure there is an audible click when mounting battery on the battery charger to
ensure proper mounting. Otherwise, injury or damage may occur.
3. Place the battery on the battery charger. Push the top of the battery against the mounting
bracket until there is an audible click.
NOTE: The charge LED will illuminate. When charged, the LED will stop illuminating.
NOTE: It will take approximately four hours to charge a battery that requires a full charge.
4. Lift up on the handle on the back of the battery.
5. Lift the battery up and away from the battery charger.
Make sure there is an audible click when mounting battery onto the control box to
ensure proper mounting. Otherwise, injury or damage may occur.
6. Place the battery on the control box. Push the top of the battery against the mounting
bracket until there is an audible click.
Handle
(STEPS 1, 2, 4 and 5)
Electric Portable Patient Lift - RPA600-1E
CAUTION
CAUTION
Battery
Charger
(STEP 3)
Audible click
when properly
installed
(STEPS 3 and 6)
FIGURE 3.5 Charging the Battery
18
Battery
Control Box
(STEP 6)
Part No 1078988