Installing the Shifter Handle
NOTE: For this procedure, refer to
FIGURE 2.3.
1. Line‐up the shifter handle threads with
threaded opening in the base.
2. Turn the shifter handle clockwise and
securely tighten into the base.
Attaching the Battery Charger Mounting Bracket to the
Wall
NOTE: For this procedure, refer to FIGURE 2.4.
1. Place the battery charger mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches from the pencil mark and drill one mounting hole.
4. Install the bottom mounting screw until there is an approximate 1/8‐inch gap between the
screw head and the wall.
5. Put the battery charger mounting bracket onto the bottom mounting screw.
6. Drill the other two mounting holes.
7. Screw the mounting screws through the battery charger mounting bracket and into the
wall. Tighten securely.
Make sure there is an audible click when mounting battery on the battery charger to
confirm proper mounting. Otherwise, injury or damage may occur.
8. Put the battery charger in place on the mounting bracket.
9. Plug the battery charger into an electrical outlet.
NOTE: An LED will illuminate when power is applied to battery charger.
FIGURE 2.4 Attaching the Battery Charger Mounting Bracket to the Wall
Part No 1078988
CAUTION
Mounting Bracket
Mounting
Screws
Bottom Mounting Screw
Shifter Handle
FIGURE 2.3 Installing the Shifter Handle
13
Electric Portable Patient Lift - RPA600-1E
SECTION 2—ASSEMBLY
Threads
Opening in Base