Stp Port Settings - Planet FNSW-2400PS User Manual

• Bridge Priority
• Hello Time
• Max Age
• Forward Delay
• Bridge Status
• Root Status
Table 4-23 Descriptions of the STP Bridge Settings Configuration Screen Objects

4.7.2 STP Port Settings

This section introduces detail information of STP Port Settings of POE Web Smart Ethernet Switch; the screen in
4-40 appears and Table 4-24
The switch with the lowest value has the highest priority and is selected
as the root. If the value is changed, the user must reboot the switch.
The value must be a multiple of 4096 according to the protocol standard
rule.
The time that controls the switch to send out the BPDU packet to check
STP current status.
Enter a value between 1 through 10.
The number of seconds a switch waits without receiving Spanning-tree
Protocol configuration messages before attempting a reconfiguration.
Enter a value between 6 through 40.
The number of seconds a port waits before changing from its Rapid
Spanning-Tree Protocol learning and listening states to the forwarding
state.
Enter a value between 4 through 30.
The Status of Bridge.
The Status of Root.
descriptions the STP Port Settings Configuration of POE Web Smart Ethernet Switch.
Figure 4-40 STP Port Settings Web Page Screen
User's Manual of FNSW-2400PS
Figure
- 48 -