Features Used While On A Call; Placing Calls On Hold; Using Call Park - Inter-Tel 7000 8662 User Manual

F U
EATURES SED
The following features are primarily used for active or incoming calls.

Placing Calls On Hold

When you place a call on hold, the held party hears music on hold or silence, depend-
ing on your system configuration. While the call is on hold, the system periodically
rings your endpoint as a reminder.
To place a call on hold:
Press
1.
Hang up or place another call.
2.
To return to a held call:
Lift the handset or press
1.
Press
2.
If more than one call is on hold, switch between held calls (call hop) by pressing the
flashing

Using Call Park

Use Call Park to place calls on hold to a designated "orbit" location. After the call is
parked to the orbit location, it can be picked up (answered) by any subscriber.
To use Call Park:
During the call, press
1.
Enter a 1- to 10-digit orbit number (for example,
2.
A confirmation notice appears.
Dial the extension number for which the parked call is intended, and then
3.
announce the parked call and the orbit number.
Hang up. You are disconnected from both parties.
4.
If the parked call is not picked up, it will be redirected to the subscriber who parked
the call after the Park Recall timer expires (about two minutes).
To pick up a parked call:
Press
1.
Enter the orbit number, and then press
2.
20
W
HILE ON A
or the menu button.
HOLD
(handsfree).
or the flashing
LINE
button assigned to the call.
LINE
PARK
CALL PARKED
SUCCESSFULLY
or the menu button.
PKUP
PICKUP
C
ALL
button.
or the menu button.
PARK
1 1
.
#
®
Inter-Tel Model 8662 Endpoint User Guide
), and then press .
1 #