Troubleshooting - DeLonghi ECAM23.210 Instructions For Use Manual

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot
The coffee is thin or
not creamy enough.
The coffee is delivered
too slowly or a drop at
a time.
Coffee does not come
out of one of the
spouts.
The frothed milk has
large bubbles
The milk is not frothed
Steam delivery stops
The appliance does not
come on.
POSSIBLE CAUSE
The cups were not preheated.
The infuser has cooled down because 2/3
minutes have elapsed since the last coffee
was made.
Low coffee temperature is set.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
The spouts are blocked.
The milk is not cold enough or is not semi-
skimmed.
Cappuccino maker dirty.
A safety device stops steam delivery after 3
minutes.
It is not plugged into the mains socket.
Plug into the mains socket.
REMEDY
Warm the cups by rinsing them with hot
water (Please note you can use the hot water
function).
Before making the coffee, warm the infuser by
pressing the
In the menu, set a high coffee temperature.
Turn the grinding adjustment knob one
click anticlockwise towards "1" while the
coffee mill is in operation (fig. 10). Continue
one click at a time until coffee delivery is
satisfactory. The effect is only visible after
delivering two coffees (see "Adjusting coffee
mill", page 12).
Use pre-ground coffee for espresso coffee
makers
Turn the grinding adjustment knob one click
clockwise towards "7" while the coffee mill is
in operation (fig. 10).
Continue one click at a time until coffee
delivery is satisfactory.
The effect is only visible after delivering 2
coffees (see the section: "Adjusting the coffee
mill" on page 12).
Clean the spouts with a toothpick.
You should ideally use skimmed or semi-
skimmed milk at refrigerator temperature
(about 5°C). If the result is still disappointing,
try another brand of milk.
Clean as described in the section "Cleaning
the cappuccino maker after use" on page 31.
Wait, then activate the steam function again.
It is not plugged into the mains socket.
Place the main switch in the I position (fig. 1).
21
button.