Table of Contents
Advertisement
82543GC Gigabit Ethernet Controller Specification Update
TX_RING_LENGTH
TX_DESC_HEAD
TX_DESC_TAIL
TX_INTERRUPT_DELAY
RX_PB_HEAD
RX_PB_TAIL
TX_PB_HEAD
TX_PB_TAIL
FLOW_CONTROL RX THRESH HI
FLOW_CONTROL RX THRESH LO
Affected Docs:
82543GC Gigabit Ethernet Controller Developer's Manual, Order #751596-001. Note: this is an obsolete
document. It has been replaced by the combined data sheet/developer's manual documents indicated in the
preface of this spec update.
2. Auto Speed Detect Function Requires CTRL.SLU Bit to Be Set
Problem:
Setting the Set Link Up (SLU) bit is a prerequisite for the Auto Speed Detect Enable (ASDE) bit in the Device
Control Register to operate correctly. Asserting CTRL.SLU does not actually force link-up unless the link
indication input indicates that the 82543GC device is connected to a PHY device with valid link.
Documentation will change to explain the complete behavior.
Affected Docs:
82543GC Gigabit Ethernet Controller Developer's Manual, Order #751596-001. Note: this is an obsolete
document. It has been replaced by the combined data sheet/developer's manual documents indicated in the
preface of this spec update.
3. Values Programmed to Some Registers While in Reset Do Not Persist
Problem:
This behavior is related to erratum #4, Some Registers Cannot Be Accessed During Reset. The erratum was
corrected, preventing infinite PCI retries, but values in certain registers will not be retained after the reset state
ends. Documentation will change to explain which registers are affected.
Affected Docs:
82543GC Gigabit Ethernet Controller Developer's Manual, Order #751596-001. Note: this is an obsolete
document. It has been replaced by the combined data sheet/developer's manual documents indicated in the
preface of this spec update.
4. JTAG Port Operation
Problem:
The JTAG interface as described in the Developer's Manual is not compliant to the IEEE 1149.1 specification
and only supports the IDCODE instruction. However, the pin description tables in the datasheet (also the text in
the Developer's Manual) does not describe the capabilities of this interface and some readers may think that full
boundary scan is supported.
The pin description tables and text will change so the function is described as the "Test Access Port (IDCODE
function)" instead of "JTAG".
Affected Docs:
OR-2711 82543GC Gigabit Ethernet Controller Advance Information Datasheet Rev. 2.01 and OR-2710
82543GC Gigabit Ethernet Controller Developer's Manual Rev. 2.01.
22
00428
00430
00438
00440
08000
08008
08010
08018
00160
00168
03808
03810
03818
03820
02410
02418
03410
03418
02168
02160
Advertisement
Table of Contents
