Table of Contents
Advertisement
Press Modify to modify the community pool. You can setup the access authority.
SNMP Status: Enable
Access Right: Deny for deny all access
Read for access read only
Write for access read and write.
Community: it serves as password for access right.
After configuring the community pool, press OK.
6.4.2.2 Trap host pool
SNMP trap is an informational message sent from an SNMP agent to a manager. Click Modify to
modify the trap host pool.
Version: select version for trap host. (Version 1 is for SNMPv1; Version 2 for SNMPv2).
IP Address: type the trap host IP address
Community: type the community password. The community is setup in community pool.
Press OK to finish the setup.
The browser will prompt the configured parameters and check it before writing into NVRAM.
Press Restart to restart the gateway working with the new parameters and press Continue to
setup other parameters.
GRT-504 4-Wire G.SHDSL.bis Firewall Router User's Manual
90
Advertisement
Table of Contents
