Trap Configuration - Planet MGSW-28240F User Manual

•
Engine ID

4.3.3 TRAP Configuration

Configure SNMP trap on this page. The SNMP trap configuration screen in
The SNMP Trap Configuration page includes the following fields:
Object
•
Trap Mode
•
Trap Version
•
Trap Community
SNMP version is SNMPv3, the community string will be associated with SNMPv3
communities table. It provides more flexibility to configure security name than a
SNMPv1 or SNMPv2c community string. In addition to community string, a
particular range of source addresses can be used to restrict source subnet.
Indicates the SNMPv3 engine ID. The string must contain an even number(in
hexadecimal format) with number of digits between 10 and 64, but all-zeros and
all-'F's are not allowed. Change of the Engine ID will clear all original local users.
Figure 4-3-2: SNMP Trap Configuration Page Screenshot
Description
Indicates the SNMP trap mode operation. Possible modes are:

Enabled: Enable SNMP trap mode operation.

Disabled: Disable SNMP trap mode operation.
Indicates the SNMP trap supported version. Possible versions are:

SNMP v1: Set SNMP trap supported version 1.

SNMP v2c: Set SNMP trap supported version 2c.

SNMP v3: Set SNMP trap supported version 3.
Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.
User's Manual of MGSW-28240F
Figure 4-3-2
94
appears.