Disassembly
To remove the Upper Heater Assembly:
1. Remove the Air Tunnel Cover. (See
.)
Cover
2. Remove the 3 Phillips-head screws that attach
the Air Tunnel Outlet to the oven. (See
.)
Outlet
3. Lift and position the Air Tunnel Outlet to the
right.
4. Remove the wiring from the wire ties.
5. Disconnect wires from the TCO.
6. Disconnect the 2 heater wire harnesses.
7. Using a fl at blade screwdriver, straighten the 2
left side folded lock tabs. Remove 5 Phillips-head
screws from the heater shield.
TCO
Tab (1 of 2)
Air Tunnel
Air Tunnel
Wire Tie
Disconnect
Wire Tie
Disconnect
Screwdriver
Note: Insulation is positioned underneath the heater
shield. In the following step, note the position of the
insulation for proper placement when installing the
heater shield.
9. Lift the heater shield from the top of the oven.
10. Using a fl at blade screwdriver, straighten the
folded lock tab. Remove 3 Phillips-head screws
that attach the heater cover.
Heater Cover
11. Lift the heater cover from the top of the oven.
12. Remove 2 Phillips-head screws that attach the
heater to the oven.
– 47 –
Tab
(Continued Next Page)