13. Carefully lift the heater from the oven.
Bottom View of Upper Heater Assembly
Ceramic Heater
Halogen Heater
– 48 –
Lower Heater Ceramic
•
Location (See
Bottom View
•
375 Watts
•
Approximately 3 Amps
•
Approximately 38 Ω
•
For operating algorithms, see Lower Heater
Ceramic in the
Load Algorithm Chart
•
Disassembly. (See
Disassembly
Troubleshooting
1. Does the display operate properly?
• If no, see
VFD Board,
• If yes, go to step 2.
2. Is Lower Heater Ceramic staying on all the time
or not coming on?
• If heater is staying on, go to step 8.
• If heater is not coming on, go to step 3.
3. Pivot the Control Panel Assembly out from the
oven. (See
Control Panel Removal
4. To gain better access to components, remove
the wires that plug into the large relays on the
Relay Board. (See
Relay Board
that the Smart Board CN103 wire harness (See
.) is routed through.
Smart Board
5. Set oven for Speedcook, Lower Lamp power
level at 10. (See
Operating Modes
instructions.)
.)
.
.)
troubleshooting step 1.
.)
.) Cut the wire tie
for set up
(Continued Next Page)