Check Microwave Assembly; Ti)R Rerirculation - GE JVM2070 Installation Instructions Manual

Installation Instructions
CHECK MICROWAVE ASSEMBLY
Exhaust Adaptor (absent
on models shipped tot
recirculation exhaust)
Microwave
" Place tile microwave in its upright position, with tile
top of tile trait facing up.
" Tile microwave oven may be shipped assembled for
top exhaust (adaptor installed)
or fin" recirculation
exhaust (adaptor absent).
• If tile microwave was shipped for recirculation
exhaust, skip to C5. If shipped fin" top exhaust,
proceed with C4.
ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
_ Remo_e Damper [] I,ift off tile
and save t,_ _, blower
screw that plate and
holds . - "" ° attached
blower adaptor
plate to { fl'om tile
Ill icFowave. ', illicrowave.
Back of ,
-_ Microwave '
_ Slicle exhaust adaptor to one side and remo_e it.
NOTE; Tile exhaust adaptor with damper is not
needed for recirculating models. You mm want to
sa',e theln for possible fllture use.
_ Remoxe and tile that holds tile blower
sa'_e screw
inotoi" to tile
illiCi'owa_e.
_ Blower Plate
,,_ Back of
Microwave
_ Carefully pull out tile blower unit. Tile wires
will extend tar enou,,h_ to allow xou to adjust tile
blower trait.
_Roll tile blower trait 90 ° so that tim blade openings
are tacing toward tile front of tile microwaxe.
AFTER: Fan Blade
OoPe£iangs Facing
_ Place tile blower trait back into tile o )enino
[ &"
CAUTION; Do not pull or stretch the blower unit
wiring, Make sure the wires are not pinched,
2O