Cisco Small Business AP541N Administration Manual page 42

Setup
LAN Settings
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Table 7 describes the fields to view or configure on the LAN Settings page.
Table 7 LAN Settings Field Descriptions
Field Description
DNS name (host name) for the access point.
Hostname
The DNS name has the following requirements:
MAC address for the Ethernet port on this access point. This
MAC Address
is a read-only field that you cannot change.
Enter a number between 1 and 4094 for the management
Management
VLAN ID VLAN ID used on your network.
The default management VLAN ID is 1.
Enable or disable VLAN tagging. If you enable the untagged
Untagged VLAN
VLAN, all traffic is tagged with a VLAN ID.
By default all traffic on the access point uses VLAN 1, the
default untagged VLAN. This means that all traffic is
untagged until you disable the untagged VLAN, change the
untagged traffic VLAN ID, or change the VLAN ID for a VAP or
client using RADIUS.
Provide a number between 1 and 4094 for the untagged
Untagged VLAN
ID VLAN ID. Traffic on the VLAN that you specify in this field is
not tagged with a VLAN ID.
If you select DHCP, the access point acquires its IP address,
Connection
Type subnet mask, DNS, and gateway information from a DHCP
server.
If you select Static IP, you must enter information in the Static
IP Address, Subnet Mask, and Default Gateway fields.
The static IP address of the access point. This field is
Static IP
Address disabled if you use DHCP as the connection type.
• Maximum of 20 characters
• Only letters, numbers and dashes. Double quote (") is
not a valid character.
• Must start with a letter and end with either a letter or a
number
3
37