Preparation; Supplied Accessories; Connections; Connecting Video Equipment - Sony UP-25MD Instructions For Use Manual

Preparation

Supplied Accessories

This printer is packed with the following accessories.
Check that nothing is missing from your package.
Paper feed tray (1)
Stopper (1)
Before Using This Printer (1)
Thermal head cleaning cartridge (1)
CD-ROM (Instructions for use) (1)
Notes
• Retain the original carton and packing materials in case
you have to transport this unit in the future.
• When transporting the printer, remove the ink ribbon and
paper feed tray, and lock the internal thermal head. For
details, see "Transportation" on page 64.
12
Supplied Accessories / Connections

Connections

To enable printing, video equipment to act as an input
signal source, and a video monitor to display images or
menus must be connected.
The following diagrams illustrate how to make the input,
output and remote control connections. Use this as a guide
when connecting the cables required to transmit signals to
and from the equipment to be used for printing.
Notes
• Turn off the power of each device before attempting to
make any connections.
• Connect the AC power cord last.

Connecting Video Equipment

Connect the video equipment providing the video images
to be printed.
Connect the video equipment which will be used in actual
printing, using the following diagram as a guide.
Connections for HDTV-signal input and output
Use the RGB/YPbPr/SYNC video signal input and output
connectors to connect equipment that will input and output
HDTV signals.
In addition, set the NTSC/PAL switch on the rear panel of
the printer as follows, based on the video system (NTSC/
PAL) you will use.
Video system Switch position
NTSC • Up
PAL • Down
Supported signals for the RGB/YPbPr/SYNC video signal
input and output connectors are as follows.
NTSC setting: 480/59.94i (SD), 1080/59.94i, 720/59.94p
PAL setting: 576/50i (SD), 1080/50i, 720/50p