Connecting The Video Monitor - Sony UP-25MD Instructions For Use Manual

NTSC/PAL
a)
switch
to VIDEO
INPUT
Connecting
to S VIDEO
cable (with
INPUT
DIN 4-pin
connectors)
75-ohm
coaxial
cable with
to S VIDEO
BNC
output
connectors
connector
to composite
video output
connector
Video equipment
a) Set the switch to match your video signal system. Set the
switch to the upper position to set the video signal system to
NTSC. Set the switch to the lower position to set the video
signal system to PAL. To switch the video signal system, turn
the power off once, then change the setting. Then, turn the
power on again. If you change the setting with the power on,
this mode will not be switched.
b) When YPbPr signal is input, it is not necessary to connect to
the SYNC connector.

Connecting the Video Monitor

Connect a video monitor to view captured images and to
check those to be printed. Connect a suitable video monitor
which will be used in actual printing, using the following
diagram as a guide.
to wall outlet
AC power cord
(not supplied)
to AC IN
to RGB/YPbPr/
b)
SYNC INPUT
75-ohm
coaxial cable
with BNC
connectors
to RGB/YPbPr/
SYNC output
connectors
NTSC/PAL
a)
switch
to VIDEO
OUTPUT
to S VIDEO
Connecting
OUTPUT
cable (with
DIN 4-pin
connectors)
75-ohm
coaxial
cable with
BNC
to S VIDEO input
connectors
connector
to composite
video input
connector
Video monitor
a) Set the switch to match your video signal system. Set the
switch to the upper position to set the video signal system to
NTSC. Set the switch to the lower position to set the video
signal system to PAL. To switch the video signal system, turn
the power off once, then change the setting. If you change the
setting with the power on, this mode will not be switched.
b) When connecting the video monitor only to the RGB/YPbPr/
SYNC OUTPUT connector without connecting to SYNC
connector, set OUTPUT SYNC in the OUTPUT SETUP menu
to ON.
c) When YPbPr signal is output, it is not necessary to connect to
the SYNC connector.
to wall outlet
AC power cord
(not supplied)
to AC IN
to RGB/
YPbPr/
SYNC
b)
OUTPUT
75-ohm
coaxial cable
with BNC
connectors
to RGB/
YPbPr/SYNC
input
c)
connectors
13
Connections