Lighting Illustration - Charmglow 720-0578 Assembly & Operating Instructions

Main burner lighting illustration
Step 1: Make sure the lid is open
Step 2: Push and turn the Main Burner
knob slowly to IGNITE/HI. Burner
should light immediately. Adjust knob
as desired after burner is lit.
Step 3: If burner does not light up, turn
the knob to OFF and repeat lighting
procedure. If burner does not light up
after step 2, turn the knob to OFF, wait 5
minutes, and repeat lighting procedure
or light by match
Rear burner & Searing side burner lighting
illustration
Step 1: Push and turn Rear Burner or Sear Burner
Knob slowly to IGNITE/ON. At the same time,
press the electronic ignition button to light the burner.
Once it is lit, release electronic ignition button, and
Hold the Rear Burner or Sear Burner knob for another
15 seconds to be sure the burner stays lit.
Step 2: Release the electronic ignition button
and knob.
Step 3: If ignition does not occur in 5
seconds, turn the knob (s) to OFF, wait 5
minutes and repeat the lighting procedure
or light by match.

Lighting Illustration

21