Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Charmglow 720
Summary of Contents for Charmglow 720
- Page 1 Stainless Steel Gas Grill USE AND CARE GUIDE MODEL NO.: 720-0396 ® ® FOR OUTDOOR USE ONLY Comsumer: Retain this manual for future reference. Installer: Leave this manual with consumer. PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE DO NOT RETURN TO PLACE OF PURCHASE...
- Page 2 SAFETY INSTRUCTIONS ***** WARNING ***** • DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open Lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department •...
-
Page 3: Table Of Contents
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions…………………………3 Using the side burner…………..………20 Placement of the grill………………………7 Care & Maintenance ………………21 Trouble Shooting…………………..……22 SECTION TWO SECTION SIX Side shelf Assembly…………………………8 Exploded View………….………….……25 Side Burner Assembly …….………………..8 Parts List ……………………..….………26 Battery assembly……………………………10 Grilling Hints……………………..………27 Rotisserie Kit Assembly……………………11 Grill Cooking Chart ………………..……28... -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING DO NOT USE ALUMINUM FOIL TO LINE Do not try lighting this appliance without first THE GRILL RACKS OR GRILL BOTTOM. reading the “LIGHTING INSTRUCTIONS” section This can severely upset combustion airflow or of this manual. - Page 5 SAFETY INSTRUCTIONS WARNING ELECTRICAL GROUNDING INSTRUCTIONS This appliance (rotisserie motor) is equipped with a plug and should be plugged directly into a properly grounded receptacle. When installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1 DO NOT cut or remove the grounding prong from this plug.
- Page 6 SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING: Always keep your face and body as far away from the burner as possible when lighting. WARNING: IMPORTANT! BEFORE LIGHTING… Inspect the gas supply hose prior to turning the gas “ON”. If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use.
- Page 7 SAFETY INSTRUCTIONS TESTED IN ACCORDANCE WITH ANSI Z21.58A CHILDREN SHOULD NOT BE LEFT ALONE OR CSA1.6A-2006 STANDARD OUTDOOR UNATTENDED IN AN AREA WHERE THE GRILL IS COOKING GAS APPLIANCES. THIS GRILL IS BEING USED. NEVER ALLOW THEM TO SIT, FOR OUTDOOR USE ONLY. STAND OR PLAY ON OR AROUND THE GRILL AT ANY TIME.
-
Page 8: Placement Of The Grill
It is necessary to clean them periodically for optimum performance. The burners will The 720-0396 Charmglow Grill is designed for optimum only operate in one position and must be mounted performance without the use of briquettes. Do not place correctly for safe operation. -
Page 9: Side Shelf Assembly
SIDE SHELF ASSEMBLY 1. The screws used to attach the side shelf are already screwed into the right side burner And left side panel(see the figure below).remove the screws from the right side burner And left side panel, install the side shelves and tighten screws as the figure show below. - Page 10 Assemble the control knob of side burner and tighten it using the wrench. Insert valve venturi into the side burner and tighten securely using an adjustable wrench. Put the four fix pieces onto the side burner manifold (two for each side), and tighten securely with 4pcs screws (5/32*10mm).
-
Page 11: Battery Assembly
Connect ignite wire with valve. 70 0 BATTERY ASSEMBLY Firstly, connect the rear burner igniter wire onto the electric igniter. Secondly, in order to install the battery, remove the ignition button housing. Please keep the positive pole of the battery facing toward you. Insert the battery into the housing. Replace the ignition button housing after battery is installed. -
Page 12: Rotisserie Kit Assembly
ROTISSERIE KIT ASSEMBLY Screw the rotisserie motor mount on the left side shelf first, put the rotisserie motor on the mount as shown in the figure below. Assemble the rotisserie skewer as shown in the figure below. -
Page 13: Propane Tank Assembly
PROPANE TANK ASSEMBLY 1. Attach regulator to the propane tank by turning the regulator handle clockwise (FIGURE A). 2. Turn off LP supply at cylinder when appliance is not in use. (FIGURE A) 1. Put the gas tank into the gas tank tray. Then tighten up the gas tank retention kit for fixing the gas tank as shown in the figure 1 below. -
Page 14: Gas Hook-Up
Total gas consumption (per hour) of 720-0396 grill with all CONNECTION: burners on “IGNITE/HI”: Your grill is equipped with gas supply orifices for use only with liquid propane gas. -
Page 15: Precautions
PRECAUTION • Never store an LP gas tank indoors. If you store your gas A tank of approximately 12 inches in diameter by 18-1/2 inches grill in the garage or other indoor location, always high is the maximum size LP gas tank to use. You must use an disconnect the LP gas tank first and store it safely outside. -
Page 16: Leak Testing
LEAK TESTING GENERAL Gas flow check: Although all gas connections on the grill are leak tested at Each grill burner is tested and adjusted at the factory prior to the factory prior to shipment, a complete gas tightness shipment; however, variations in the local gas supply may make check must be performed at the installation site due to it necessary to adjust the burners, the flames of the burners possible mishandling in shipment, or excessive pressure... -
Page 17: Installer Final Check
INSTALLER FINAL CHECK Unit tested and free of leaks. Specified clearance maintained 24” from User informed of gas supply shut off valve location. combustibles. All internal packaging removed. Knobs turn freely. Burners are tight and sitting properly on orifices. Pressure regulator connected and set for 11.2” W.C. -
Page 18: Operating Instructions
OPERATING INSTRUCTIONS General use of the grill and rotisserie The skewer for the rotisserie is assembled into the motor Each main burner is rated at 10,000 BTU/hr. The main grill assembly by placing the pointed end into the motor, and burners encompass the entire cooking area and are side then sliding the grooved bushing into the slot at the ported to minimize blockage from falling grease and debris. -
Page 19: Lighting Instructions
LIGHTING INSTRUCTIONS WARNING: IMPORTANT! these conditions exist call our customer service line. If BEFORE LIGHTING… the flame is yellow, it indicates insufficient air. If the Inspect the gas supply hose prior to turning the gas flame is noisy and tends to lift away from the burner, it “ON”. -
Page 20: Lighting Illustration
LIGHTING ILLUSTRATIONS Main& side burner lighting illustration Rear burner lighting illustration Make sure the lid is open. . Push and turn the Rear Burner knob to IGNITE/ON position and hold in for 3-4 seconds while continue to hold, push electronic ignition button, until burner is lit. Once it is lit, release electronic ignition button, and still hold in the Rear Burner knob for another 15 seconds to be sure the burner... -
Page 21: Using The Side Burner
USING THE SIDE BURNER control knob counterclockwise to the “IGNITE/HI” position. If the burner does not light, turn the control knob to “OFF”. If the smell of gas is detected and the WARNING: IMPORTANT! igniter is not functioning, immediately turn the control USING THE SIDE BURNER: knob “OFF”. -
Page 22: Care & Maintenance
CARE & MAINTENANCE OF SIDE BURNER SIDE BURNER CLEANING: Clean the exterior of the burner with a wire brush. Clear any clogged burner ports with a straightened paper clip. Never enlarge the burner ports. Never use a wooden toothpick as it may break off and clog the port. -
Page 23: Trouble Shooting
TROUBLE SHOOTING SPIDER AND INSECT WARNING!!! Spiders and insects can nest in the burners of the grill 1. The smell of gas in conjunction with the burner and cause the gas to flow from the front of the burner. flames appearing yellow. This is a very dangerous condition, which can cause a 2. - Page 24 flames are not correct replace regulator. Full size cover does not fit the grill. --Cover may be incorrect for your grill. It may be a tight fit. Ensure the cover correct length for your grill. Measure it left to right. Compare to the grill’s measurement.
- Page 25 --Elevation is the principal cause, however cold weather affect mixture. Burner adjustment may be required. Refer to manual for adjustment procedures. --Grill is in a windy location.
-
Page 26: Exploded View
EXPLODED VIEW... -
Page 27: Parts List
Model 720-0396 PARTS LIST REF# Description REF# Description Main Lid Door Handle Temperature Gauge Fix Piece Of Door Shaft Logo Lighting Rod Main Lid Handle Heat Insulating Spacer Right Square Pipe Of Front Main Lid Handle Heat Insulating Cover Right Side Panel... -
Page 28: Grilling Hints
GRILLING HINTS Use a spatula instead of tongs or a fork to turn the The doneness of meat, whether rare, medium, or well meat, as a spatula will not puncture the meat and let done, is affected to a large degree by the thickness of the juices run out. -
Page 29: Grill Cooking Chart
GRILL COOKING CHART FOOD WEIGHT OR FLAME APPROXIMATE SPECIAL INSTRUCTIONS THICKNESS SIZE TIME AND TIPS VEGETABLES Slice. with butter margarine. Wrap in heavy-duty foil. Grill, turning occasionally. Fresh: Beets Medium 12 to 20 minutes Grill, turning once. Brush Carrots occasionally with melted butter Turnips or margarine. - Page 30 Rare 1 inch High 10 to 15 minutes Remove excess fat from edge. Slash remaining fat at 2-inch intervals. Grill, turning once. 1-1/2 inch High 14 to 18 minutes Medium 1 inch Medium to 13 to 20 minutes 1-1/2 inch High 18 to 25 minutes Well-done...
-
Page 31: Grill Recipe Suggestion
GRILL RECIPE SUGGESTIONS BBQ SALMON 1 20 oz. Can pineapple chunks in juice aluminum foil. Bake covered 25 minutes 2 large salmon steaks drained In medium bowl, combine shrimp on medium with the lid of your BBQ grill 2 tbs. oil and scallops. - Page 32 ½ tsp. salt Bring marinade to boil on the side 1 chicken bouillon cube ½ tsp. celery salt burner in a saucepan. Add remaining 1 can beer for basting sauce ¼ tsp. garlic powder 1/3 c. water and peanut butter. Stir to ½...
-
Page 33: Converting To Natural Gas
Please note the chart below to give an easy reference for the various orifice opening sizes for the different valves in the grill. Orifice Sizes and BTU Ratings Model Number 720-0396 Components Orifice Size... - Page 34 CONVERTING TO NATURAL GAS INSTRUCTIONS FOR CONVERTING TO NATURAL GAS Tools required for converting from LP to NG Screwdriver + is used for removing the screws 8mm Nut Driver is used for changing the main tube burner orifice Screwdriver - is used for turning the Low/High Flame 14mm Wrench is used for releasing the brass adapter of flex tube 10mm Wrench is used for changing the rear burner orifice Allen Key is used for removing the control knobs...
- Page 35 GAS CONVERSION Main Tube Burner Conversion Steps： 1. Remove the rotisserie kit, warming rack, cooking grids, flame tamers and tube burners from the firebox. 2. Locate orifice on end of valve and remove by turning counterclockwise with a 8mm Nut Driver. CAUTION! When converting the grill, screw the orifice in and out of the stem gently due to the breakable thread.
- Page 36 GAS CONVERSION Side Burner Conversion Steps： 1. Fix orifice nut with 18mm Wrench. Then locate orifice and remove by turning counterclockwise with 6.1mm Wrench. 2. Insert NG orifice by hand, then secure and turning clockwise with 6.1mm Wrench in tightly.
- Page 37 GAS CONVERSION Rear Burner Conversion Steps： 1. Remove the eight screws securing the rear baffle. Then take out the Rear Baffle. 2. Locate rotisserie orifice and remove by turning counterclockwise with a 10mm Wrench. 3. Attach and screw in tightly the NG rotisserie orifice. 4.
- Page 38 GAS CONVERSION For Main tube burner and Side burner Conversion Only You will need to adjust the High Flame setting screw when converting the barbecue from Propane to Natural Gas. Please follow the steps as detailed below 1. Remove each Control Knob of main tube burners and side burner by loosing the socket head grub screw holding it to the Valve stem.
- Page 39 GAS CONVERSION NG Hose and Regulator Conversion 1. Turn all knobs to OFF, and turn off LP supply at cylinder, then take off the brass adapter of LP regulator from the manifold with a wrench. 2. Attach the NG regulator to the manifold, and screw tightly with the wrench. 3.
-
Page 40: Limited Warranty
LIMITED WARRANTY MODEL 720-0396 STAINLESS STEEL OUTDOOR GAS GRILL Nexgrill Industries, Inc. warrants to the original consumer purchaser of each Outdoor Gas Grill that when subject to normal residential use, it is free from defects in workmanship and materials for the periods specified below.