General Lubrication; Auger Shaft - Ariens 926321 Owner's/Operator's Manual

GENERAL LUBRICATION

(Figure 17)
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 37.
Sno-Thro should be lubricated (Figure 17) at
beginning of season or every 25 operating
hours.

Auger Shaft

To grease auger shaft, remove shear bolt
nuts and shear bolts per instructions in Shear
Bolts on page 28. Apply grease at the grease
zerks and then turn the auger assemblies on
the auger shaft. Replace shear bolts.
Apply oil to auger shaft end bushings.
Figure 17
EN - 26
Oil
Grease