General Lubrication; Auger Shaft - Ariens Sno-Thro Hydro Pro 28 Track Owner's/Operator's Manual

GENERAL LUBRICATION

(Figure 19)
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on belts.
NOTICE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 37.
Sno-Thro should be lubricated (Figure 19) at
beginning of season or every 25 operating
hours.

Auger Shaft

To grease auger shaft, remove shear bolt
nuts and shear bolts per instructions in Shear
Bolts on page 29. Apply grease at the grease
zerks and then turn the auger assemblies on
the auger shaft. Replace shear bolts.
Apply oil to auger shaft end bushings.
2x
Figure 19
EN - 27
Oil
Grease