General Lubrication - Ariens 924119 Owner's/Operator's Manual

GENERAL LUBRICATION

Sno-Thro should be lubricated (Figure 9) at beginning
of season or every 25 operating hours.
IMPORTANT: DO NOT allow grease or oil to get on
friction wheel, drive disc or belts.
IMPORTANT: Wipe each fitting clean before and after
lubrication.
NOTE: Apply Stens Mix Hi-Temp Grease or equivalent
to the lubrication fittings. See Service Parts.
Auger Shaft
NOTE: To grease auger shaft, remove shear bolt nuts,
and shear bolts. Turn auger on shaft while applying
grease at zerk fittings. Replace shear bolt per instruc-
tions in Service and Adjustments.
2
1 1
6
7
3
1. Auger and Shaft
2. Discharge Chute
3. Sprocket/Pinion
Assembly
4. Axle Shaft
Figure 9
1
1
8
4
5
5. Shift Lever Arm
6. Pinion Chain
7. Hex Shaft
8. Shift Link
CLEAN BATTERY
WARNING: AVOID INJURY. Read and
understand Battery Safety Rules in Safety
section before attempting any maintenance.
IMPORTANT: Battery is maintenance free. Do not
tamper with or attempt to open battery. See Service
and Adjustments for charging procedures.
Terminals
Keep battery and its terminals clean.
IMPORTANT: Remove battery from unit before
cleaning.
Remove corrosion from battery terminals and cable
connections with a wire brush, then wash with a weak
baking soda solution.
After cleaning, apply a thin coat of grease or petroleum
jelly to terminals and cable ends to retard corrosion.
CLEAN ENGINE
Refer to Engine Manual for detailed instructions.
GB - 16
(Model 333,334,502,503)