Ariens 926321 Owner's/Operator's Manual page 31

1
4
3
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin
Figure 26
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
IMPORTANT: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. Auger/Impeller must stop
within 5 seconds when Attachment
Clutch/Impeller Brake lever is
released.
Remove Attachment Cable Slack
(Figure 27 and 28)
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Loosen hardware securing belt cover to
unit.
NOTE: DO NOT completely remove the
hardware from unit.
3. Remove belt cover.
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel up or down to lengthen or shorten
cable and remove all cable slack
(Figure 27).
1
2
3
2
OS7185
5. With the attachment clutch disengaged,
check that the attachment idler arm
lightly touches the frame (Figure 28).
6. Tighten jam nut on the adjustment
barrel.
\
With the attachment clutch disengaged,
check the attachment idler arm position
here. The attachment idler arm should
lightly touch the frame.
EN - 31
1. Attachment Clutch Cable
2. Adjustment Barrel
3. Jam Nut
Figure 27
Figure 28
OS7185
OS7191
OS7196