LOG pLaceMent
LOG pLaceMent
Burner Grate Assembly
1. Hold Log #1 with the flat side of the log
parallel to the right brick. Place the log on
the pin on the right rear of the log bracket.
Make sure to fit the notch in the front of
the log over the fettle. There should be a
slight gap (approximately 3/8") between
the log and the brick.
Log #2
20300293
LG753
VHLDV burner grate
Figure 37
LG755
Left front log #2
Figure 36
LG753
LG754
VHLDV right log #1
LG755
Figure 38
Resolution Direct Vent Gas Fireplace
Log #1
2. Hold Log #2 in your left hand
with the thick end to the left.
Position the log on the left front
just behind the fettle and seat
the log on the two (2) pins on the
left fettle bracket. The right end
of the log should rest along the
back edge of the front burner.
LG754
29