Table of Contents
Advertisement
Using your Extractor
For best performance, you should switch on the extractor 15 minutes before
starting to cook and leave it to run for approximately 15 minutes after the end
of cooking.
Control Panel
A – Light button
B, C, D – Speed level buttons
E – Power off button
F – Timer button
To switch the extractor light on or off
•
Press button A.
To switch on the extractor or to change the speed at any time when the
extractor is running
•
Press button B, C or D for the first, second or third speed level as required.
To switch the extractor off
•
Press button E.
The intensive function
•
The extractor is equipped with an intensive function which runs for ten
minutes before returning to the previous selected speed. To activate the
intensive function, press and hold button B for two seconds B. Button E will
flash whilst the intensive function is on. To cancel the intensive function, press
button E again.
The timer
•
The extractor is equipped with a timer that allows the extractor to run for 15
minutes before switching off automatically.
•
To activate the timer, touch button F.
Please note
The timer cannot be activated when the intensive function is on.
The clean air function
•
The extractor is equipped with a clean air function that switches on the motor
for ten minutes every hour at speed one.
•
To activate the clean air function, press and hold button F for two seconds
when the appliance is off. To return to normal function, press the
button B, C or D for the speed required. To switch off the extractor, press
button E. Buttons C and F will flash whilst the motor is running, and button F
will be lit during the fifty minutes when the motor is not running.
Fig. 1
2
Advertisement
Table of Contents
