Table of Contents
Advertisement
Installation
Secure the stainless section to the motor body as shown in
the following images
1. Refit the 2 screws (A) in the side (fig. 1 3)
2. Refit the 4 screws (A) in the base (fig. 1 4)
Finally, fit the 2 black cover caps (taped to the underside of
the filter cover) into the holes on the side.
Connecting the internal wires
The extractor is now mounted and secured to the wall; the
electrical connections are must be made in order for the
extractor to function; proceed as follows: -
1. Ensure that there are no trapped wires - The mains lead
and control wires are easily trapped when securing the
stainless section to the motor.
2. Locate the main terminal box (on the left as you look
at it) and remove the 2 screws, shown as D in figure 15.
Connect the main connector plug (Shown as B in the
diagram) and replace the cover.
3. Locate the control terminal box (on the right) and
remove the 2 screws. Connect the connector as shown in
the diagram (A) and refit the terminal cover.
Fig. 15
Fig. 13
Fig. 14
8
Advertisement
Table of Contents
