Table of Contents
Advertisement
Installation
Your extractor can be used to recirculate or extract to the
outside, either through a rear wall or via the ceiling void, as
shown in fig 6
Preparing the unit for installation.
Place the unit on a table and remove the grease filter as
shown in figure 7.
Remove the 4 screws securing the motor housing to the
stainless section and then the two screws supporting the side
of the motor body as shown in figure 8.
Stand the unit on its end and carefully remove the fixing
bracket and motor assembly by lifting it clear of the stainless
Fig. 6
section.
Fig. 7
Fig. 8
6
Advertisement
Table of Contents
