Programming The Remote - Zenith D60WLCD Installation And Operating Manual, Warranty

Programming the Remote

The remote control of your HD receiver is a multi-
brand or universal remote control that can be
programmed to operate most remote-controllable
components of other manufacturers.
Note that the remote control may not control all
models of other brands.
Test your remote control.
1
To find out whether your remote control can
operate the component without program-
ming, turn on the component such as the
VCR and press the corresponding mode but-
ton (VCR) on the remote control while
pointing at the component. Test the POWER
and CH +/- buttons to see if the component
responds properly. If not, the remote
requires programming to operate the device.
2
Turn on the component to be programmed.
Then press the corresponding mode button
on the remote control.
3
Press the POWER button and the MUTE but-
ton simultaneously. Then the remote control
is ready to program the code for the corre-
sponding component.
4
There are two ways to find the right code for
the component.
A. If you press the CH +/- buttons repeat-
edly, the code will change one at a time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off.
5
Press the EXIT button to store the program.
6
Test the remote control functions to see if
the component responds properly. If not,
repeat from step 2.
P A G E 4 6
vcr cable dvd sat
tv
mode light
2
source
antenna video
comp1 comp2
1 2
4
4 5
7 8
0
3
mute
vol
swap pipch- pipch+ pip
flashbk surf freeze
menu
record stop
pause rew
play
power
3
front
rgb
3
6
9
enter
ratio
4
ch
exit
5
skip
ff
206-03726