Cable Box Connections - Zenith D60WLCD Installation And Operating Manual, Warranty

Cable Box Connections

Some cable services require the use of a cable box to decode pre-
mium channels and pay-per-view. Using the Loop Out to Decoder
connection option, and programming your remote, you can con-
nect your cable box so that you only need your MBR remote to
tune to premium and non-premium channels. By connecting a
cable box directly to your Entertainment Machine, as shown using
the LOOP OUT, you make the cable box another channel tuning
source available using your remote.
Locate the Antenna/Cable 2 jack on the
1
back of your TV. Connect the cable that
runs from the wall directly to the jack.
Now find the Loop Out jack.
Connect the cable from this jack to the
2
Input jack on the back of your cable box.
Locate the Output jack on the back of
3
your cable box. Connect this to the
Antenna/Cable 1 jack on the back of your
TV.
To view the premium stations, press the
4
TV button on your remote and select the
other Cable source (Ant/Cable 1). Then
tune the channel number on your cable
box for HBO, CINEMAX, SHOWTIME, etc.
To view non-premium channels press the TV
button and select Ant/Cable 2. Then run EZ
Scan to find all available channels and
store them in memory.
This can be combined with any other
equipment you may want
to hook up. Hook cable directly into the
TV, then to the cable box. From there, the
cable box goes to the next device, down
the line, until the last piece, which con-
nects back to the TV using the
Antenna/Cable 1 jack.
206-03726
Antenna
Cable TV
wall jack
Cable box
In
Out
Rf coaxial wire
(75ohm)
ANT/CABLE2 ANT/CABLE1
LOOP OUT
INPUT INPUT
S-VIDEO
VIDEO
P A G E 1 1