Zenith D60WLCD Installation And Operating Manual, Warranty page 25

PIP/POP/SPLIT Sources
Press the PIP button on the remote con-
1
trol in PIP mode to activate POP (Picture
-out-of-Picture) mode.
Press the EXIT button to exit POP mode
2
or press the PIP button again to activate
Split mode.
Press the LEFT/RIGHT arrow in Split
3
mode to select CH+/-, Swap, or Source.
• CH+/-: Use the UP/DOWN arrow to
select a program for the sub picture.
Changing programs in the sub picture
is only possible if the PIP source is
NTSC RF signal.
To change the program for the main
picture, use ch +/- button.
• Swap: Use the UP/DOWN arrow to
swap main and sub pictures.
• Source: Use the UP/DOWN arrow to
select a source for sub picture.
Your choices are : TV, Video1/2, Front,
Component 1/2.
RGB-PC input cannot used for the PIP
picture source.
Press the EXIT button to exit Split mode.
4
Press the FREEZE button to capture and
freeze the currently-viewed sub picture in
PIP or Split mode.
Do not display a fixed image on the
screen for long periods of time.
206-03726
tv vcr cable dvd sat
mode light power
source
video front
antenna
comp1 comp2 rgb
1 2 3
4 5 6
7 8 9
0
enter
mute ratio
vol ch
swap pipch- pipch+ pip
flashbk surf freeze
menu
exit
record stop skip
pause rew
play ff
3
1/2
3
3
2/4
P A G E 2 5