Programming The Remote - Zenith D60WLCD Installation And Operating Manual, Warranty

Programming the Remote

The remote control of your HD receiver is a multi-
brand or universal remote control that can be
programmed to control most remote-controllable
components of other manufacturers.
Note that the remote control may not control all
models of other brands.
Test your remote control.
1
To find out whether your remote control can
operate component without programming,
turn on the component such as the VCR and
press the corresponding mode button (VCR)
on the remote control while pointing at the
component. Test the POWER and CH +/-
buttons to see if the component responds
properly. If not, it requires programming.
Turn on the component to be programmed.
2
Then press the corresponding mode button
on the remote control.
Press the POWER button and the MUTE but-
3
ton simultaneously. Then the remote control
is ready to program the code for the corre-
sponding component.
There are two ways to find the right code of
4
the component.
First, if you press the CH +/- buttons
repeatedly, the code will change one at a
time. Press the POWER button after each
code change. If the right code is found, the
device will turn off.
Second, enter the code number using the
digit buttons on the remote. The right code
numbers for the corresponding component
can be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the program.
5
Test the remote control functions to see if
6
the component responds properly. If not,
repeat from step 2.
P A G E 4 6
vcr cable dvd sat
tv
mode light
2
source
video
tv
comp1 comp2
1 2
4
4 5
7 8
0
3
mute
vol
swap pipch- pipch+ pip
flashbk surf freeze
menu
record stop
pause rew
play
power
3
front
rgb
3
6
9
enter
ratio
4
ch
exit
5
skip
ff
206-3726