Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-10YKH-E Service Manual

8-2. Installation Diagram of Indoor and Outdoor Units

For installation of the indoor unit, use the paper pattern on the back.
Front cabinet
Front panel
5 Deodorizing
filter
6 Purifying
filter
Before install the wireless
remote control
• With the remote control cover
open, load the batteries
supplied correctly, observing
their polarity.
2 Wireless remote control
3
Batteries
Cover
RAS-10YA-ES RAS-13YA-ES
RAS-10YAH-ES RAS-13YAH-ES
A 400
B 45
Clip anchor
Hook
Hook
Pan head
wood screw
9
8 Remote
control
2 Wireless
holder
remote
control
Be sure to use the
Electric parts cover
Loop the connective cable
(about 100 mm in diameter
and 300~350 mm long).
600
100
– 28 –
For the rear left and left piping
Hook
1 Installation
plate
Do not allow the drain hose to
get slack.
4 Mounting screw
Shield pipe
Rear
Extension
drain hose
(Option:
RB-821SW)
Wall
Insert the cushion between
the indoor unit and wall,
and lift indoor unit to make
work easier.
Cut the piping hole
sloped slightly
Make sure to run the drain
hose sloped downward.
The auxiliary piping can be
connected the left, rear left,
rear, right or bottom.
Right
Rear left
Left
Bottom
Insulation of refrigerant pipes
insulates the pipes separately,
not together.
6 mm thick heat resisting
polyethylene foam