Electrical Work; When The Installation Plate Is Directly Mounted On The Wall - Toshiba RAS-10YKH-E Service Manual

<When the installation plate is directly mounted
on the wall>
(1) Securely fit the installation plate onto the wall by
screwing it in the upper and lower parts to hook
up the indoor unit.
(2) Install the installation plate horizontally in the
wall.
(3) To mount the installation plate on a concrete wall
with anchor bolts, utilize the anchor bolt holes as
shown in the above figure.
CAUTION
When installing the installation plate with mount-
ing screw, do not use the anchor bolt hole.
Otherwise the unit may fall down and result in
personal injury and property damage.
Anchor bolt
Projection
15mm
or less
5mm dia, hole
Clip anchor
4 Mounting screw Ø4 x 25
Fig. 8-4-4
MODEL
Power source
Maximum running current
Plug socket & fuse rating
Wiring
*
No adjustment is necessary.
Installation plate
(Keep horizontal direction)
RAS-10YKH-E
RAS-10YKH-ES
7,5A
16A
1mm or more
2
CAUTION
Failure to firmly install the unit may result in per-
sonal injury and property damage if the unit falls.
• In case of block, brick, concrete or similar type
walls, make holes in the wall.
• Insert clip anchors for appropriate
screws.
NOTE :
• Install the installation plate using 4 to 6 pieces of
mounting screw securing four corners with screws.

8-4-2. Electrical Work

(1) The supply voltage must be the same as the
rated voltage of the air conditioner.
(2) Prepare the power source for exclusive use with
the air conditioner.
CAUTION
• Use power specified above table.
• This appliance can be connected to the mains
in either of the following two ways.
(1) Connection to fixed wiring:
A switch or circuit breaker which disconnects
all poles and has a contact separation of at
least 3 mm must be incorporate in the fixed
wiring. An approved circuit breaker or
switches must be used.
(2) Connection with power supply plug:
Attach power supply plug with power cord and
plug it into wall outlet. An approved power
supply cord and plug must be used.
NOTE :
• Perform wiring works so as to allow a generous
wiring capacity.
~
50Hz 220–240V Single-phase
*
– 32 –
T
mounting
RAS-13YKH-E
RAS-13YKH-ES
12A
16A
1,3mm or more
2