Lighting The Stove - Stanley Erin Installation And Operating Instructions Manual

Before lighting the stove check with the installer that the installation work and
commissioning checks described in the installation instructions have been carried out
correctly and that the chimney has been swept clean, is sound and free from any
obstructions. As part of the stove's commissioning and handover the installer should
have demonstrated how to operate correctly.
1. Before lighting the stove, ensure that any build up in the firebox has been removed (see
De-Ashing Section) and that the ashpan has been emptied.
2. Open firedoor and open the primary air inlet by sliding the control knob on the ashpit
door to the right hand side.
3. Open the secondary air inlet by turning it anti-clockwise.
4. Cover with crumpled pieces of paper.
5. Lay 10-12 pieces of kindling on top of the paper towards the back of the firebox.
6. Ignite and close the firedoor.
7. Under no circumstances should any flammable liquid i.e. petrol, paraffin etc.,
be used to light the fire.
8. When the kindling is well alight open the firedoor and add more kindling of a larger size
to sustain the fire. Close the firedoor.
9. When a hot bed of coals is established add the normal fuel.
10. When well lighted, adjust the air controls to give the required heat output.
11. Always open the firedoor first before opening the ash door. Do not only open the ash
door to de-ash the appliance as this will cause the fire to run away and may cause dam-
age if left open for a prolonged period , with the firedoor closed.
Re-fuelling - Open the firedoor and reload, close the firedoor.
LIGHTING
9
Fig.11