Device Used; Setup Password; Mouse Button - AMX G3 Instruction Manual

Figure 108
DEVICE BASE button
Note
If four devices are used, and
the base address is 128, then
the touch panel will use
device numbers 128, 129,
130, and 131 consecutively.
Figure 109
DEVICE USED button
Figure 110
SETUP PASSWORD button
Warning
If you change the password
number, record the new
number and keep it in a
secure place. If you change
the password, AMX cannot
provide you with the
password.
Note
You can still control the
Touch Panel with your finger
when mouse control is active.
Color Active-Matrix LCD Touch Panels

Device used

Press the DEVICE USED button to open the keypad (Figure 109) and set the panel's
device number from 1 – 4. Each device number supports up to 255 channel code
button assignments. The multiple device setting option allows you to create up to
four unique Touch Panel buttons and/or pages.

Setup password

Press the SETUP PASSWORD button to open the keypad shown in Figure 110 and
set the numeric SETUP page password.
The password number range is 1 through 9,999. (Do not use zero.) Do not change
the SETUP page password unless you are concerned about unauthorized access to
the Touch Panel pages.
Press to clear the number in the keypad display.
CLEAR
Press to enter the new password into Touch Panel memory and
ENTER
close the keypad.

Mouse button

Press the MOUSE button (Figure 111) to open the Mouse Setup page shown in
Figure 112.
Touch Panel Program Reference 69