Table of Contents
Advertisement
Figure 9
AXU-CV(/PB) or AXU-
CA(/PB), and BB-TP1 cutout
dimensions
Color Active-Matrix LCD Touch Panels
.170
.35
[8.9 MM]
.52
3.22
2.94
[74.7 MM]
TWO .170 [4.3 MM] DIA HOLES PROVIDED ON
Insert a flat head screwdriver into the release slot on the AXU-CV(/PB)'s or
2.
AXU-CA(/PB)'s bezel and remove the engraved overlay.
Lay the AXU-CV(/PB) or AXU-CA(/PB) facedown onto a soft cloth and
3.
remove the four screws from the low-profile back box. Remove the back box
and discard.
Place the BB-TP1 into the cutout and mark the threaded insert positions as
4.
shown in Figure 9.
Remove the BB-TP1 and drill four #6-32 insert holes. Then, place a threaded
5.
insert into each hole.
Disconnect the AXlink connector from the AMX Central Controller that
6.
supplies power and data to the AXU-CV(/PB) or AXU-CA(/PB). Then,
disconnect the DB-9 connector from the external RS-232 device connected to
the AXU-CV(/PB) or AXU-CA(/PB).
Thread the incoming AXlink and RS-232 wiring through the BB-TP1 knockout.
7.
8.187
(FRAME)
7.80
7.46
7.10
[180.3 MM]
.125 [3.2 MM] MAX
.125
1.70
4.25
1.70
CUTOUT
Installing Touch Panels
4.50
(FRAME)
11
Advertisement
Table of Contents
