Axu-Cv(/Pb) And Axm-Cv(/Pb) - AMX G3 Instruction Manual

148 1MB Memory Upgrade
Carefully pry the 256KB IC out of the socket connector with a non-conducting
5.
flat-blade tool and insert the two 512KB ICs in the sockets indicated in
Figure 200.
Rotate the circuit card back to the original position and place it in the CATP
6.
housing.
Place the bottom panel onto the touch panel and align the screw holes. Insert
7.
the four Phillips-head screws and tighten.
Plug all connectors back into the touch panel.
8.

AXU-CV(/PB) and AXM-CV(/PB)

To install the EXM-1MB Memory Upgrade into the AXU-CV(/PB) or AXM-CV(/PB)
touch panel:
Discharge the static electricity from your body by touching a grounded object.
1.
Insert a flat-blade tool into the release slot on the CATP's bezel and remove the
2.
engraved overlay.
Remove the four #6-32 mounting screws and carefully lean the CATP
3.
backward to expose the AXlink and RS-232 (optional) wiring.
Disconnect the AXlink and RS-232 connector and remove the CATP from the
4.
back box or equipment rack.
Flip the touch panel facedown onto a soft cloth. Figure 201 shows the
5.
connectors on the circuit card.
Color Active-Matrix LCD Touch Panels