How To Set Up A Client-To-Gateway Vpn Configuration; Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Dg834 V3 - NETGEAR DG834 Reference Manual

Reference Manual for the ADSL Modem Router DG834

How to Set Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway (see
• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834 v3" on page 7-6
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 7-11
configures the NETGEAR ProSafe VPN Client endpoint.
22.23.24.25
DG834
192.168.3.1
PCs
Figure 7-3
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834 v3
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
VPN Tunnels in Special Circumstances" on page 7-36
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at "Planning a VPN" on page
7-6
Figure 7-3) involves the following two steps:
VPN Tunnel
Table 7-2 on page
7-3.
v2.3, May 2007
0.0.0.0
PC
(Running NETGEAR
ProSafe VPN Client)
7-4. If you have special requirements
to set up the VPN tunnel.
Virtual Private Networking (Advanced Feature)
uses
"How to Set Up