Tray Chaining And Auto Continue - Konica Minolta magicolor 7300 Reference Manual

Printer Error Accounting
Capturing the information each time the printer experiences an error allows
you to analyze the types of errors and the down-time each error causes.
For More Information
See "Printer-based Accounting" on page 268 for details about the Accounting
records that are saved in the Accounting file on your printer's hard disk.

Tray Chaining and Auto Continue

Tray Chaining
You can configure the printer to automatically switch input trays during a print
job when the first tray runs out of media. This is called tray chaining. Tray
chaining can be enabled from the printer's control panel (Paper/Input Tray/
Tray Chain menu) and from the Administrator Mode/System tab/User Choice
topic/Paper window of PageScope Light. See the following section "Auto
Continue" for additional information concerning the use of tray chaining.
Auto Continue
If paper of the size specified for the print job is not loaded in the printer,
printing stops and a message appears, instructing that paper of the size
specified for that print job be loaded.
If the Auto Continue function is used, printing of the print job can automati-
cally continue using the paper loaded in the printer when paper of the size
specified for the print job is not loaded.
If the Auto Continue function is enabled, the page size of the print job is auto-
matically adjusted to fit the size of paper in the printer so it can be printed on
the size and type of paper loaded in the printer.
The Auto Continue function can be enable or disabled from the printer's con-
trol panel (Sys Default menu/Auto Continue) or from the PageScope Light
window (Administrator mode/System tab/User Choice/System Default).
194
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Tray Chaining and Auto
Continue