SOYO SY-K7VIA User Manual page 74

BIOS Setup Utility
3-5.4 FDC Controls
FDC Controls
Onboard FDD
controller
3-5.5 Onboard Serial Ports
Onboard Serial
Ports
Onboard
Serial Port 1 /
Serial Port 2
UART 2 Mode
If [UART 2 Mode] is set to [IrDA]/[ASKIR]
IR Function
Duplex
TX,RX inverting
enable
Setting
Disabled
Enabled
Setting Description
Disabled
3F8/IRQ4 Choose serial port 1 & 2's I/O
address.
Do not set port 1 & 2 to the
2F8/IRQ3
same address except for
Disabled or Auto.
3E8/IRQ4
2E8/IRQ3
Auto
Standard The second serial port offers
these InfraRed interface
HPSIR
modes.
ASKIR
Half Choose [Half] or [Full]
Duplex to set UART2 in half
Full
duplex mode or full duplex
mode respectively. Refer to
your IR device specifications
to select the suitable mode.
No,Yes This item allow you to enable
the TX, RX inverting which
No, No/
depends on different H/W
Yes, No/
requirement. To avoid any
Yes, Yes.
error to your system, it is
recommended to leave it to its
defaults setting.
Description
Turn off the on-board
floppy controller
Use the on-board floppy
controller
70
SY-K7VIA
Note
Default
Note
Default
(port 1)
Default
(port 2)
Default
Default
Default