SOYO SY-K7VIA User Manual page 46

Hardware Installation
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
CMOS Setup Utility – Copyright ( C ) 1984-1999 Award Software
4Soyo Combo Feature
4Standard CMOS Features
4Advanced BIOS Features
4Advanced Chipset Features
4Integrated Peripherals
4Power Management Setup
4PnP/PCI Configurations
Esc : Quit
F10 : Save & Exit Setup
4PC Health Status
áâàß
Change CPU's Clock & Voltage
42
Load Optimized Defaults
Load Fail - Safe Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
: Select Item
SY-K7VIA