Monochrome Panel Board Removal - Epson Stylus Photo895 Service Manual

EPSON Stylus PHOTO 895/785EPX/915/825

4.2.2.2 Monochrome panel board removal

1. Remove the housing. (Refer to Section 4.2.1 "Housing Removal")
2. Remove four screws (C.B.P. 3x8, F/ZN) and detach the monochrome panel board.
3. Remove two screws (C.B.S. 3x6, F/ZN) located on the rear of the monochrome
panel board and detach the panel shield plate.
Figure 4-9. Monochrome panel board
4. Remove the FFC from the monochrome panel board connector.
Pay attention since the buttons of monochrome panel will be not
C A U T I O N
fixed anymore if the monochrome panel board is detached.
Disassembly and Assembly
C.B.P 3x8 F/ZN
Tightening torque for screw
• C.B.S 3x6, F/ZN screw for monochrome panel board: 6 +/- 1 kgf.cm
• C.B.P 3x8, F/ZN screw for panel shield plate: 6 +/- 1 kgf.cm
Disassembly
Revision B
79