Outline; Adjustment Items - Epson Stylus Photo895 Service Manual

EPSON Stylus PHOTO 895/785EPX/915/825

5.1 Outline

This section provides explanations on the adjustments required after dismantling and
reassembling this product.

5.1.1 Adjustment items

The items for adjustment are listed below. Ensure that all instructions related to these
adjustment items are implemented without fail to ensure trouble-free operations of this
product when performing the adjustments described below.
Table 5-1. Adjustment items
1 2 3
EEPROM
Head ID
Parallel
Service item
initial
adjustments input
setting
Printhead
NA NA NA
removal
Printhead
NA NA
replacement
Main board
NA
replacement
CR Unit
replacement NA NA
or removal
CR Motor
NA NA NA
replacement
Printer
mechanism NA NA
replacement
Waste Ink pad
NA NA NA
replacement
NOTE: The circle (O) indicated that adjustments must be carried out. The
numbers inside the circles indicate the adjustment sequence.
NOTE: The following adjustment procedure is not required with this product.
• Head leaning adjustments
Adjustment
4 5 6 7
Protection
Memory
Ink Bi-D USB ID
Counter
card drive
Change Adjustment input
confirmation
NA NA NA
NA NA
NA
NA NA NA
NA NA NA
NA NA
NA NA NA NA
This section explains the detailed procedures for adjustment programs.
In order to ensure stable printing functions and maintain quality between each printer
mechanism, it is necessary to set up the adjustment information for each mechanism.
It is therefore necessary to set up and save the correct mechanism information with the
use of the adjustment program when the printer mechanisms, the main circuit board,
and the printer head have been replaced.
C A U T I O N Make sure the power supply to the printer has been switched off
when removing parts or assembling parts during adjustment
program execution.
8
reset
NA
NA
NA
NA
NA
NA
Outline
Revision B
117