Polaris 2000 Universal Snow Owner's Safety And Maintenance Manual page 81

MAINTENANCE
NOTE: Do not touch a halogen bulb with bare fingers. Oil from skin leaves a resi-
due, causing a hot spot which will shorten the life of the lamp.
Removing Halogen Bulbs - Low Beam
1. Pinch ends of the spring (1) together
and lift until it releases from the spring
retainer.
2. Lift spring carefully around wire
harness (2) and flip to outside of
housing.
3. With the wire harness attached to the
bulb (3), withdraw bulb from housing.
4. Grasp bulb by metal base and
carefully separate bulb
harness.
Installing the Bulb
1. Hold bulb by metal base and install into wire harness.
2. Insert bulb into housing.
3. Carefully flip spring back into housing placing it around wire harness.
4. Squeeze spring together until it is over the spring retainer and release.
5. Verify headlight aim.
Removing Halogen Bulbs - High Beam
1. Remove the wire harness
2. Gasp the bulb firmly and twist it 1/2
turn counterclockwise.
NOTE: Do not touch a halogen bulb with
bare fingers. Oil from skin leaves a resi-
due, causing a hot spot which will shorten
the life of the lamp.
3. Remove the bulb from housing and
replace with new bulb.
4. Place the bulb and housing back
inside the hole and turn the housing
1/2 turn clockwise to lock into place.
5. Reinstall the wire harness to the
housing.
76
2
1
from
3