Back Panel - Honeywell Dolphin 70e Black User Manual

DOCK LEDs
The Dock LED indicates if the terminal is properly seated in the charging well. Each well has
a dedicated Dock LED, which illuminates blue when a terminal is properly seated in the
charging well.

Back Panel

Port 1: 10/100Mbps RJ45 Ethernet Port
RJ45 Ethernet Ports
The Net Base contains two RJ45 Ethernet ports. You can connect the Net Base to an Ethernet-
compliant device to facilitate Ethernet communication to and from the terminal by plugging a
standard CAT-5 Ethernet cable into one of the two Ethernet ports provided. The second RJ45
Ethernet port can be used for connection to an additional device such as a printer, workstation,
eBase, or another Net Base.
Note: The Net Base does not use a Spanning Tree Protocol (STP). When both RJ45 Ethernet ports are
used, do not connect both Net Base interfaces to the same layer 2 LAN.
Each Ethernet port has a dedicated green and yellow status LED.
Status
No Ethernet Link
10Mbps Ethernet Connection Established
100Mbps Ethernet Connection Established
Data transfer in progress
Note: The terminal and Ethernet link must be set up properly to allow the terminal to communicate to other devices
and/or the Internet. For more information, see
Yellow LED (Qty. 1 Per Port)
Port 2: 10/100Mbps RJ45 Ethernet Port
Green LED (Qty. 1 Per Port)
Yellow LED
Off
Off
On
Connection Speed Dependent
(see above)
Establishing Ethernet Communication
DC Power Jack
Green LED
Off
On
On
Flashing
on page 13-5.
13 - 3